adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。 - The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。 - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - The main wear mechanisms of nylon 1010 composites are fatigue fracture and adhesive wear and it can be observed that the GF is rubbed, fractured and peeled off under dry friction condition.
干摩擦下的复合材料磨损以疲劳断裂和粘着为主，且纤维出现磨损、断裂及从基体中剥落的现象。 - With the increase of the concentrations of peroxide solutions, the degree of adhesive wear weakened and the friction coefficient decreased. In high concentration of peroxide solutions, the main wear mechanism of ceramic materials was corrosive wear, abrasive wear and the friction coefficient increased.
随着H202介质溶液浓度的增大，粘着作用减弱，摩擦系数减小，高浓度H202介质溶液中，Si3N4陶瓷材料的磨损以腐蚀磨损和磨粒磨损为主，摩擦系数增大。 - The results show that the plow effect between friction pairs and adhesive area of friction surface could be effectively reduced with incorporation of SiC particles, which decrease the mass-loss wear of composite plating layer.
结果表明：SiC颗粒的加入能有效地降低摩擦副之间的犁沟效应及摩擦表面发生粘着的面积，从而减少镀层的磨损。 - Near the latter point, the strain velocity of adhesive friction and that of slide friction is near to be equal and friction coefficient has almost no effect to the strain velocity with slide friction.
在轧件与轧辊分离处，变形速度为零，在这点附近粘着摩擦和滑动摩擦变形速度值接近相等，摩擦系数几乎不影响滑动摩擦情况下的变形速度。 - The results show that samples have self-lubricity after copper deposition. The surface modification method can control inherent adhesive wear of pure Ti to an extent, which can reduce wear and friction coefficient.
结果表明：复合铜之后的试样具有一定自润滑性，这种表面改性方法使纯钛固有的黏着磨损得到了一定的控制，减小磨损，降低了摩擦因数。